DGI – FAQ
1. Is it necessary to grease the collection substrates and why?
2. What kind of grease should be used for greasing the collection substrates?
3. What kind of collection substrates are allowed to be used with the DGI?
4. What kind of filters should be used with filter stage?
5. How often should I clean the impactor?
6. What type of cleaning agent is recommended to be used with the impactor?
1. Is it necessary to grease the collection substrates and why?
Usually it is recommended to grease the collection substrates to prevent particle bounce. In case of liquid aerosols or aerosols known to be free of bounce greasing can normally be omitted.
In most applications it is difficult to estimate whether the particles are bouncy or not, so it is recommended to grease the substrates in any case in the beginning of the measurements. If bouncing occurs, it can be seen as particle deposits on top of the collection plates which are the lower surfaces of the jet plates.
2. What kind of grease should be used for greasing the collection substrates?
The most commonly used grease in impactor measurements is Apiezon-L, because of its purity and low evaporation properties. Dekati Ltd provides Apiezon- L for substrate greasing but other types of greases may also be used as long as the grease has low evaporation characteristics, a thin and smooth layer of used grease can be applied on the substrates, and the grease has low enough viscosity so that the air flow inside the impactor does not blow the grease out of the impactor collection substrates.
Before applying the grease on the substrates, it should be dissolved in a suitable solvent e.g. carbon tetrachloride, toluene or acetone. Dissolve the grease in the solvent by adding the grease in the solvent little by little until you reach grease/solvent ratio of about 1/20-1/30. The Apiezon-L grease is also available from Dekati as a spray.
3. What kind of collection substrates are allowed to be used with DGI?
The collection substrates can be made of any material as long as the substrates are very thin, have a smooth surface and are poreless. The diameter of the collection substrates is 47 mm. If the filters are too thick they may change the dimensions inside the impactor too much so that the calibrated D50 values are no longer valid. If the substrates do not have a smooth surface they may also change the D50 calibration values. If the substrates are porous, the flow inside the impactor may penetrate the substrate and some of the smaller particles can be lost in the substrate by filtration resulting in a distorted distribution. More details on the suitable filters can be found here.
4. What kind of filters should be used on the filter stage?
The filters used in the DGI filter stage are Ø 70 mm in diameter. Many type of filters can be used, the requirements are that the filter should have high collection efficiency for particles smaller than 200 nm and it should not obstruct the flow inside the impactor too much.
5. How often should I clean the impactor?
The cleaning interval of the impactor depends on the sample concentration and the type of particles that are measured, i.e. how much particle matter is actually collected inside the impactor. The maximum recommended loading for one impactor stage is approximately 10 mg. If the impactor is not cleaned often enough, it will start affecting the calibrated D50 values and flow rate of the impactor.
6. What type of cleaning agent is recommended to be used with the impactor?
The impactor is made of stainless steel, so almost any type of solvent will do. The solvent has to dissolve the measured particles efficiently; for example salts dissolve easily to water, grease to non-polar solvents. The parts should be placed in an ultrasonic bath in the suitable solvent for several minutes.